• Repairs must be performed based on recommendations from the
manufacturer. Maintenance and repairs that require the assistance of other
qualified personnel must be performed under the supervision of an
individual adequately trained in the use of flammable refrigerants.
• Ducts connected to this appliance must not contain potential ignition
sources.
• WARNING – Risk of fire. Flammable refrigerant used. To be repaired only by
trained service personnel. Do not puncture refrigerant tubing.
• WARNING – Risk of fire. Flammable refrigerant used. Dispose of properly in
accordance with federal or local regulations.
• WARNING – Risk of fire. Flammable refrigerant used. Consult repair
manual/owner's guide before attempting to service this product. All safety
precautions must be followed.
• WARNING – Risk of fire. Flammable refrigerant used. Follow handling
instructions carefully in compliance with national regulations.
GENERAL SAFETY INSTRUCTION
• This appliance is intended for indoor use only.
• Do not power this appliance through an electrical socket under repair or that
has not been installed properly.
• Do not use the unit:
A: near a fire source;
B: in an area where oil is likely to spill or splash;
C: in an area exposed to direct sunlight;
D: in an area where water is likely to spill or splash;
E: near a bath, laundry area, shower, or swimming pool.
• Never insert your fingers or any other item into the air outlet. Take special
care to warn children of these dangers.
• Keep the unit upright during transport, storage, and use.
• Before cleaning the unit, always switch unit off and disconnect the power
supply.
• When moving the unit, always switch unit off and disconnect the power
supply. Move the unit slowly.
• To avoid the risk of fire, the unit should never be covered while operating.
• Electrical sockets used to power the unit must comply with local electricity
safety requirements. If necessary, please check for these requirements.
• Children should be supervised to ensure that they do not play with the
appliance.
• If power supply cord is damaged, it must be replaced by the manufacturer, a
service agent, or a similarly qualified person to avoid hazard.
www.newair.com
EN
8