Introduction To Exhaust Hose Installation - NewAir NAC14KWHD3 Manual Del Propietário

1. Twist both ends of the exhaust hose into the square fixing clip and the flat
fixing clip.
2. Insert the square fixing clip into the openings on the back of the air
conditioner (see Fig.9).
3. Place the other end of the exhaust hose on a nearby windowsill.
Installing the mounting plate:
Mounting plate installation accessories: outer plate I, outer
plate II, inner plate, screw, gasket, and nut.
Installation of outer plate accessories as shown to the right:
1. Outer plate
2. Screw
3. Gasket
4. Nut
Operating steps:
•
First, set the screw on the inner side of the outer plate of the
mounting plate, then place the gasket on the end where the screw
extends out of the outer plate. Affix it with the nut (tighten it slightly),
place the inner plate into the outer plate, adjust it to a suitable length,
and tighten the nut.
Mounting plate shown below:
www.newair.com
(Fig.9)
EN
14