ARTE confort ITAPARICA Manual De Instrucciones página 14

THANKS FOR TRUSTING IN
ARTECONFORT
Congratulations, you have just purchased an
Arteconfort ceiling fan: cutting edge technology
combined with the highest energy efficiency.
EN
WARNING
Read this instruction manual carefully before
beginning installation and save it for future
reference. In case of transfer of the device, you
must also give this instruction manual to the
corresponding person.
While using electrical appliances, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury.
If unusual oscillating movement is
observed, immediately stop using the
ceiling fan and contact the manufacturer,
its service agent or suitably qualified
persons.
CAUTION
• The mounting of the suspension system shall
be performed by the manufacturer, its service
agent or suitably qualified persons and in
compliance with local, regional and state
electricity regulations.
• Your ceiling fan must be installed along the fixed
wiring, the total disconnection of the ceiling fan
from the power supply requires the installation
of a bipolar switch (not included). The power
supply must be connected in accordance with
the norm and regulation of ABNT NBR5410
(Brazilian Standard for Low Voltage Electrical
Installation). In case of doubt, consult an
electrician you trust.
• In case of doubt, consult an electrician you trust.
• Check if the electrical specifications of this
device are compatible with your installation.
• Turn off the power before installing or repairing
the fan.
• The fan must be properly grounded to avoid the
risk of electric shock.
14
WARNING
• Use and unauthorized technical modifications
could suppose a risk of injury.
• The fan must be connected to a 127-220V 60Hz
power supply.
• Do not connect the fan motor to a current
dimmer. It could give unsatisfactory performance
(engine humming) and cause engine damage.
• Be careful while working near the spinning
blades.
• Never connect the fan to a power point but to
the ceiling itself.
• The fan must be installed so that the blades are
at least 2,3 meters above the ground.
• Ceiling fan weight: 5,1kg. The fan must be hung
from a structure capable of supporting a weight
of at least 50 kg, which is the weight of the
appliance in operation. The fixture must be able
to support the weight of the fan in motion and
should not wobble or loosen.
• Make sure that the blades do not come in
contact with any object at the installation site.
Always leave a minimum clearance of 50cm
from the tip of the blades to the wall or ceiling.
Keep in mind that the larger this space, the
better the fan's air flow will be.
• This device is designed for indoor use only. Do
not use in an open space or where it may be
exposed to water or moisture.
• Never install the appliance in a room with a
high degree of humidity.
• The fan must not be started in a room with a
gas appliance running at the same time.
• This device can be used by children aged 8
years and above and of people with reduced
physical, sensory or mental abilities or lack of
experience and knowledge if they are supervised
or instructed about the use of the device safely
and understand the risks involved. As well as
cleaning and maintenance of the device.
• Children should not play with the device.
• Before reversing the direction of rotation of the
blades stop the fan completely. This will prevent
any damage to the fan motor or controller (if
installed).
• Do not insert any object into the fan blades
while they are rotating. This can damage them
and alter the balance of the fan and the device
can fall down.
• After the fan is fully installed make sure all
fasteners are securely fastened to prevent any
wobbling or falling of the machine.
• The replacement of parts of the safety
suspension system device shall be performed by