Checking The Thermostat And Heater - Sibir V110 Instrucciones De Instalación

REPlAcINg thE WIcK
11 11 Unscrew the gallery.
12 dip the wick in kerosene a few seconds.
12
13 light the wick and allow the flame to burn until it
goes out by itself.
14 blow the ashes away and the wick should now
14
be even all the way around the wick guide. If not,
repeat the procedure.

chEcKINg thE thERmoStAt ANd hEAtER

1 Pull out the plug from the wall socket.
2 Remove the plastic cover on the thermostat.
3 Remove electrical cables from the thermostat.
3
4 by-pass the thermostat by connecting the cables
4
using tape or sticking plaster.
5 Make sure to insulate the metal ends completely.
6 Push the plug into the wall socket and put the refrig-
erator on test for at least 3–4 hours.
7 If the refrigerator gets cold the thermostat should be
replaced.
8 If the cooling unit does not get warm, replace the
heater.
!
When finished, do not forget to put
the wires back on the thermostat.
www.sibir.com
12
!
do not attempt this procedure without the proper
knowledge of electrical components.
11
3
Insulate metal ends
completely. Use tape
or sticking plaster.
4
17
14
copyright © sibir international