Kosmos Burner - Sibir V110 Instrucciones De Instalación

lIghtINg thE buRNER

KoSMoS bURneR

1 Remove the lamp glass with its sealing ring (pull
1
carefully upwards).
2 Adjust the wick to about 1 mm (0.04") above the
wick guide.
3 light the wick and allow the flame to travel around
3
the wick.
4 Turn the flame very low. It should now be even. If it
4
is not, the wick should be pressed down where the
flame is high. Usa a wire or screwdriver.
5 Replace the lamp glass with insert carefully.
6 Push the tank into the tank holder underneath the
6
cabinet at the rear of the refrigerator. Slide the tank
carefully forwards against the guide pin.
7 Carefully lift the tank by means of the lever arm
7
and check that the guide pin enters the hole in the
bracket on the left side of the burner.
8 Make sure that the sealing ring seals properly
8
against the chimney. There must be no gap be-
tween the chimney and the sealing ring.
9 Adjust the flame to medium flame and leave the
refrigerator running for 3–4 hours.
10 For further adjustment, see "Regulating the tempe-
rature > Kerosene operation".
!
• never let the flame get smoky. If it does, turn down the flame.
• never turn the flame to maximum until the chimney has been heated for 3–4 hours.
• First time using the refrigerator, smoke will appear due to paint residues in the chimney.
6
Lever arm
7
www.sibir.com
Guide pin
Lever arm
1
Sealed
8
Not
sealed
8
4
Wick guide
Sealing
ring
Sealing
ring
8
3
Very low
flame
copyright © sibir international