Work Area Precautions; Electrical Safety - Expondo S-WIGMA 225PMH Manual De Instrucciones

USER MANUAL
S-WIGMA
S-WIGMA
S-WIGMA
e x p ond o .co m
225PMH
255PMH
225PH
S-ALU 225PH
S-ALU 333PH
Rev. 07.06.2022
SAFETY WARNINGS AND PRECAUTIONS
WARNING: When using tool, basic safety precautions should al-
ways be followed to reduce the risk of personal injury and damage to
equipment.
Read all instructions before using this tool!
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric
shock, fire, and/or serious injury.
SAVE THESE INSTRUCTIONS

Work Area Precautions

1. Keep your work area clean and well lit. Cluttered benches and dark areas
invite accidents.
2.Do not operate power tools in explosive atmospheres, such as in the pre
sence of flammable liquids, gases, or dust. Power tools create sparks which
may ignite the dust or fumes.
3.Keep bystanders, children, and visitors away while operating a power tool.
Distractions can cause you to lose control. Protect others in the work area
from debris such as chips and sparks. Provide barriers or shields as needed.

Electrical Safety

1. Grounded tools must be plugged into an outlet properly installed and grounded
in accordance with all codes and ordinances. Never remove the grounding prong
or modify the plug in any way. Do not use any adapter plugs. Check with a
qualified electrician if you are in doubt whether the outlet is properly grounded.
If the tool should electrically malfunction or break down, grounding provides a
low resistance path to carry electricity away from the user.
2. Double insulated tools are equipped with a polarized plug (one blade is wider than
the other). This plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet. Do not change the plug in any way. Dou-
ble insulation eliminates the need for the three wire grounded power cord and
grounded power supply system.
Rev. 07.06.2022
EN
31