Expondo S-WIGMA 225PMH Manual De Instrucciones página 27

Technical details
Input voltage
Frequency (Hz)
Input voltage
Open circuit voltage
Degree of protection for the
housing
Insulation class
Overvoltage protection
Cooling
Gas-magnetic valve
Duty cycle WIG
Duty cycle WIG
Welding current AC WIG
Welding current E-Hand
Ignition WIG
Ignition MMA
Electrode diameter WIG
Electrode diameter MMA
Gas after-flow
Current reduction (Down
Slope)
Base current
Welding thickness
Pulse current
Pulse width
Pulse frequency
Hot-Start/Anti-Stick
Weight
Dimension (LxBxH)
52
EN
S-WIGMA 225PMH S-WIGMA 255PMH
230V, 1-Phase 230V, 1-Phase
50Hz 50Hz
T 17A T 20A
40V 60V
IP21S IP21S
F F
yes yes
fan fan
yes yes
ED 225A/ 60% ED 255A/ 60%
ED 163A/ 100% ED 187A/ 100%
5 - 225A 5 - 255 A
5 - 225A 5 - 255A
HF HF
Contact Contact
1 - 3,2mm 1 - 3,2mm
1 - 4mm 1 - 4mm
1 - 10Sec. 1 - 10Sec.
0-10 s 0-10 s
10-90% 10-90%
0,3 - 8 mm 0,3 - 10 mm
10 - 225A 10 - 255A
0,1 - 0,9 (10 - 90%) 0,1 - 0,9 (10 - 90%)
0,5 - 300Hz 0,5 - 300Hz
yes yes
13,2 kg 20 kg
440x218x355 555x220x355
Rev. 07.06.2022
START-UP
A. Unpacking
Unpack all items from the package and ensure that all items, specified within the
scope of the delivery are present.
B. Work environment
It is necessary to ensure well ventilation within the working area. The device is cooled
by the fan which ensures cooling for all internal subassemblies of the device.
(Tip! The guards must be installed in such way that the vent holes could be located
at the front side of the device) In order to leave some space for cleaning and cooling,
the device should be located within the distance of at least 15 cm (from each side)
from other objects. If the device is not efficiently cooled, the make-time decreases.
C. Conduits connection
Each device is equipped with feeder cable which supplies it with electric voltage. If
the device is connected to the current source with the voltage exceeding supply
rated voltage or improper phase is connect, it may result in serious damage of the
machine. The device which has been damages in such course does not subject to
repair under the warranty terms.
D. WIG-welding
The handle has to be take by the hand. Unto the black closing cap. Next, it is necessa-
ry to insert wolframic electrode into the collet. Next put the housing onto the collet
and tighten the holder head (Nozzle).
Rev. 07.06.2022
EN EN
53