Installation; Programming; Final Assembly; Audio Level Adjustment - Metra 99-6514B Instrucciones De Instalación

INSTALLATION

Attention! For models with an 8-inch screen, update the AXXESS interface via the AXXESS Updater
available at axxessinterfaces.com. Select "8-inch screen" once prompted to. Instructions to
update the interface are available at the end of this instruction booklet.
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the 6520 harness, into the interface.
2. Connect the factory "White" 4-pin harness removed in step 5 of Dash Disassembly to the
"Black" connector from the interface.
Note: The display screen will not function without this connection.
3. Connect the 6514 harness to the wiring harness in the vehicle.
4. Connect the climate control harness from the vehicle to the 99-6514B radio trim panel. This is the
harness that was removed in step 4 of dash disassembly .
5. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Metra recommends using the proper mating adapter from Metra.
Note: If an AXXESS steering wheel control interface (sold separately) will be used, do not
connect it until the AXXESS interface is programmed and fully functional.

PROGRAMMING

1. When the interface first boots up, the factory screen will go through a boot up sequence for
a few moments. Do not touch any controls during this process.
2. Test all functions of the installation for proper operation, before reassembling the dash. For
amplified models, also refer to the "Audio Level Adjustment" section.
Note: Reference the Troubleshooting section for factory items known to be no longer functional.
6

FINAL ASSEMBLY

1. Secure the completed radio assembly to the dash using the factory hardware.
2. Reassemble the dash in reverse order of disassembly using the 99-6514B panel.

AUDIO LEVEL ADJUSTMENT

For models with a factory amplifier:
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
3. Once at a desired level, audio level adjustment is complete.
|
386-257-1187 MetraOnline.com