AXXESS INTERFACE INSTALLATION
TABLE OF CONTENTS
Connections To Be Made . ......................................................................................................................5-6
Installing The Interface . ............................................................................................................................6
Final Assembly . .........................................................................................................................................6
Screen Operation .................................................................................................................................. 7-9
Updating The Interface . ..........................................................................................................................10
INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Used in amplified and non-amplified systems
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired for an AXXESS steering wheel control interface
• High level speaker input
• Retains balance and fade
• Ability to add an aftermarket backup camera or additional video input
• Retains factory screen
• Micro "B" USB updatable
INTERFACE COMPONENTS
• Axxess Interface • 16-pin harness with stripped leads • 6525 harness with stripped leads
TOOLS REQUIRED
• Cutting tool • Crimping tool • Tape • Connectors (example: butt-connectors, bell caps, etc.)
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio, connect as indicated:
• Red wire to the accessory wire.
Note: If using an AXXESS steering wheel control interface (sold separately), there will be a
Red wire there to connect as well.
• Orange/White wire to the illumination wire if applicable.
• Blue/White wire to the amp turn-on wire.
The following (3) wires are for aftermarket multimedia/navigation radios that provide these wires
(if not required, tape them off and disregard them).
• Light Green wire to the parking brake.
• Blue/Pink wire to the VSS or speed sense wire.
• Green/Purple wire to the reverse wire.
• Tape off and disregard the following (9) wires, they will not be used in this application:
Brown, White, White/Black, Gray, Gray/Black, Purple, Purple/Black, Green, and Green/Black
Continued on the next page
5
REV. 4/19/22 INST99-6525