Electrical Safety - ULTIMATE SPEED UPK 10 E2 Instrucciones De Funcionamiento Y De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 167
Do not dismantle or modify
the power bank with com-
pressor. This device must only
be repaired by a mainte-
nance technician.
Do not use the device in
areas with a risk of explo-
sion, e.g. near flammable
liquids, gases or powders.
Do not expose the device to
any source of heat.
Do not store in places
where the temperature can
exceed 70 °C.
Only charge in an ambient
temperature between 0 °C
and 35 °C.
Only use the AC adapter as
supplied
24
CAUTION: How to
avoid accidents and
injuries resulting from
electric shock:

Electrical safety:

Do not use the device if the
switch cannot be switched
on and off. Arrange for
damaged switches to be
replaced.
Do not carry the device by
the cable. Do not unplug
the plug from the socket by
pulling on the cable. Protect
12
GB/IE/NI/CY/MT
with the device.
the cable from heat, oil and
sharp edges.
If the cable is damaged,
unplug the plug immediately
from the socket.
Do not short-circuit the two
crocodile clips. This can lead
to a hazardous situation!
Batteries:
CAUTION!
EXPLOSION HAZARD!
Do not open or short-circuit
the power bank with com-
pressor
. This could cause
1
the device to overheat,
ignite or explode.
Do not expose the power
bank with compressor
to high temperatures. The
battery could explode.
Check the power bank with
compressor
confirm it is not leaking.
Leaking or damaged batter-
ies may cause burns if they
come into contact with skin.
In this situation, always wear
suitable safety gloves! Care-
fully wipe up the liquid with a
cloth and avoid contact with
skin and eyes. In the event
of contact with skin or eyes,
rinse immediately with clean
1
regularly to
1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido