Faq; Troubleshooting - ULTIMATE SPEED UPK 10 E2 Instrucciones De Funcionamiento Y De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 167
Attention: As soon as the
vehicle starts, remove the jump
lead
from the power bank
18
with compressor
30 seconds and firstly disconnect
the black battery clamp (B) and
then the red clamp (A) from the
battery poles. Otherwise, it could
result in dangerous situations!
Leave the vehicle engine
running.
z FAQ
Q: Question
A: Answer
Q: How long does it take to
fully charge a mobile phone
with the device?
A: With a battery capacity of
3500 mAh: Approx. 3–4 hours
if connected to the USB output
5 V
/1 A
. Approx. 2–3 hours
12
if connected to the USB output
5 V
/2 A
. Please note that
11
if the device is switched on, it will
continually use battery power while
actually charging and this can
extend the charging time.
Q: How long does the power
bank with compressor
a full charge?
A: 3–6 months. However,
we recommend recharging the
battery monthly.
20
GB/IE/NI/CY/MT
within
1
hold
1
Q: How is the power bank
with compressor
off?
A: After switching on the power
bank with compressor
the power bank switch
power bank with compressor
switches off automatically after
approximately 20 seconds if the
compressor is not started or if no
consumables are connected.
A manual switching off of the
device is not provided for.
z Troubleshooting
= problem
= cause
= remedy
The power bank with
compressor
charged, even though all
4 indicator lights
permanently lit.
It is 60% charged after a long
period out of use or in storage.
Recharge the power bank with
compressor
1
the section "Charge power bank
with compressor".
Power bank does not
respond when power bank
switch
is pressed.
9
Deep discharge protection
active on the power bank with
compressor
1
switched
1
with
1
, the
9
is not fully
1
are
13
as described in
.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido