Switch On Lighting; Using The Jumpstart Feature - ULTIMATE SPEED UPK 10 E2 Instrucciones De Funcionamiento Y De Seguridad

Safety fuse
If the device becomes overloaded or
malfunctions, the safety fuse triggers
to protect the device.
Never use a fuse with a
higher release current
strength. There is a risk
of fire!
Attention: To protect people and
property, an overheat protection
circuit has been installed for the
battery in the power bank with
compressor . This prevents an
1
overheating of the battery installed
in the device and automatically
switches off the power bank with
compressor if the battery temper-
1
ature is too high. If this happens,
allow the device to cool down prior
to re-commissioning it.
z Switch on lighting
Light mode
To switch on the LED light
„
press the power bank switch
for 3 seconds.
Press the power bank switch
„
for another 3 seconds in order to
switch the LED light
Flash mode
To switch on the LED light
„
the flash or SOS mode, first press
the power bank switch
18
GB/IE/NI/CY/MT
,
7
9
9
back off.
7
in
7
for
9
3 seconds. Then the LED light
will be permanently lit.
Briefly press the power bank
„
switch once again and the LED
9
light will switch to flash mode.
7
Briefly press the power bank
„
switch once again and the LED
9
light will switch to SOS mode.
7
There will be 3 short flashes,
3 long flashes and another
3 short flashes.
Briefly press the power bank
„
switch once again to switch
9
off the LED light
Caution! Do not look
directly at the LED lights
this can damage your eyes.
Note: It is not possible to turn on
the light while the power bank with
compressor is charging.
1
z Using the jumpstart
feature
When using the jumpstart,
„
make sure that at least 3 indica-
tor lights are permanently
13
illuminated.
1
.
7
7
B A
2. 1.
7
as