Note: You cannot charge USB
devices (e.g. mobile phone, tablet)
while the power bank with compres-
sor itself
is being charged.
1
z Using the integrated
compressor
Screw the compressed air hose
on to the hose connection
the power bank with compressor
(see Fig. C).
1
Place the device on a level and
non-flammable surface. Do not
operate the device in a dusty envi-
ronment. This is a fire risk and the
device could also be damaged.
Note: Depending on the inflatable
item, you can either use the com-
pressed air hose
together with the valve adapters
and
supplied in the scope of
22
23
delivery.
Connecting the compressed air
hose without a valve adapter
Screw the free end of the com-
pressed air hose
to the connection valve of the
inflatable item.
Connecting the compressed
air hose with a valve adapter
The valve adapters
are located in the storage com-
partment for the valve adapters
(see Fig. B).
14
of
15
directly or use it
17
directly on
17
,
and
21
22
First screw the required valve
adapter
free end of the compressed air
hose
17
Then insert the valve adapter
or
22
23
of the inflatable item (if necessary
remove the valve cap of the inflat-
able item first).
17
Remove the compressed air
hose
Connection without valve adapt-
ers
,
21
pressed connection hose
the valve of the inflatable item.
Connection with valve adapters
,
21
22
adapter off the connecting valve
on the inflatable item. Screw the
valve adapter
,
compressed air hose
21
sary, reattach the valve cap on to
the inflatable item).
Note: When disconnecting
the compressed air hose
can escape from the valve of the
inflatable item. Ensure that you
remove the compressed air hose
as quickly as possible.
Pressure Preselect Function
Switch on the power bank with
compressor
23
for the power bank
Connect the compressed air
hose
17
,
or
to the
21
22
23
.
into the connection valve
or
: Screw the com-
22
23
or
: First, pull the valve
23
,
or
21
22
17
by using the switch
1
9
of the power bank with
GB/IE/NI/CY/MT
,
21
off
17
off the
23
(if neces-
, air
17
17
.
15