vibration module (fig. 4). If you can hear a „click", it means they have been
secured properly.
•
Connect rear elements of the frame (8,4) and then slide them in the seat
frame (fig. 6).
•
Pull the belts through the covering and secure with clips on the other side.
Fasten the covering belt under the reclined cradle bracket. Note: it is an
indispensable element which assures carrying capacity of the covering (fig. 7).
•
Mount the carousel (9,10) by sliding it in the base. Now the reclined cradle
is ready.
2. Safety belts
•
To undo the belts, unfasten the buckle cover and press the key on the belt
buckle (fig. 9).
•
To fasten the belts properly, pull the child's hands through the harness, as
showed in the figure 10 and connect the belts in the buckle. Adjust the belts
length to the child's body so that they fit tight but do not cause discomfort.
•
Secure the belts with clips at the back side of the covering.
•
The belts can be adjusted at 3 levels of height.
3. How to replace battery
To replace the battery, you need a hex screwdriver (not supplied).
To replace the battery, unscrew the bolt from the cover and place 2 LR6 batteries
there, remember to follow marking. Close the cover by screwing the bolt in (fig. 12).
4. How to change height
You can set the height of the reclined cradle in one out of four available positions.
Note: The reclined cradle is equipped with a locking mechanism which secures the
product against accidental change of height. To change the height of the reclined
cradle, at first lift the backrest of the reclined cradle gently, next press the height
adjustment button (13) and finally set the desired position.
5. How to transport the reclined cradle
Pull out the bow with toys and then press the reclined cradle folding key (12).
Detach the rear part of the frame in the chair base, fold the product (fig. 14) and
secure the bracket with the belt on the reverse of the covering.
‑ 9 ‑
EN