GBC MFPP-C1 Manual De Instrucciones De Operación página 14

Crease dies
Crease Die Cleaning
Media being creased may become smeared by toner deposits
accumulating in the groove of the crease die. If this is observed follow
the procedure below to clean the die.
To clean the die:
1. Complete steps 1-4 from Section 4-A of this manual to remove
the die from the machine. Take care not to damage the chip
located at the rear underside of the die.
2. Scrape toner residue [3] from the crease die groove [2] using
a plastic pointed swab [1] or similar.
Be careful not to damage the groove of the crease die. Do not
use a metal pointed tip to remove the toner.
3. Clean excess toner particles [3] from the crease die groove [2]
using a foam or cotton swab [1].
4. Complete steps 6-9 from Section 4-A of this manual to insert
the crease die into the machine.
5. Once the die has been inserted, feed some sheets to confirm
that there is no toner marking on the sheet. If toner marking is
still observed complete the cleaning procedure again.
MFPP-C1
GB
14