Functions - Luisi Air SANREMO Instrucciones De Uso Y De Montaje

Filtering mode:
In case the appliance is used in the filtering
mode, charcoal filters are necessary which can
be purchased as accessories and installed as
shown in fig. 12.
Charcoal filters are to be fit immediately under
the grease filters, therefore you shall first fit the
charcoal filters and then the grease filters.
Even in the case of filtering mode, you will need
to provide a ducting allowing the air to go out of
the cabinet. In order to prevent the formation of
condensation, which can damage wooden and/
or electrical parts.

FUNCTIONS

Touch control (fig. 14)
A: ON/OFF control . Allows to switch the ap-
pliance on and to automatically set it at II spe-
ed . When the appliance is on at any speed, it
switches the fan off.
B: linear touch control. Allows to change the fan
speed . It is possible to change the speed only
after the appliance is switched on acting on the
ON/OFF key. Use the ON/OFF key to switch the
fan off , as it is not possible to switch the fan off
through this control.
C: Leds indicating the fan speed.
D: After 10 min from its setup, it allows to stop
the motor.
The function you set is indicated by the flashing
of "C" leds related to the set speed.
Automatic turn off:
After 4 hours of continuous working from the last
setup, the appliance turns off automatically.
Grease filters saturation:
After 30 hours of operation, the speed indica-
tors (fig. 14C) will all flash simultaneously, signa-
ling the grease filters saturation.
To reset this function, press the "TIMER" key
for at least 3 seconds, when the appliance is
switched off.
20
EN
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650m³/h. In-
ternal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer
device that automatically switches the suction
speed from 4th to 3rd speed, after 6 minutes
operation. External motor models are equipped
with remote motors that, as for internal motor ver-
sions, include a timer device that switches down
the suction speed when it exceeds 650 m3/h.
(See External Motors Instructions). Remote mo-
tors, whose air capacity exceeds 650m³/h at both
4th and 3rd speed, will have the following by de-
fault timer control functions: The suction speed
is automatically switched from 4th to 2nd speed,
after 6 minutes operation. If the appliance is wor-
king at 3rd speed, it is automatically switched to
2nd speed, after 7 minutes operation. Operation
speeds can still be changed during operation.
The energy consumption of the appliance in
stand - by mode is lower than 0.5W.
SANREMO