Ce Symbol - Eaton Ex ResistTel Instrucciones De Servicio

9. The telephone must have zero potential to open the device. The
waiting time before opening the telephone after de-energizing the
voltage is at least 2 minutes!
10. Dust must not enter the device while it is open!
11. The cover seal and the collar of the lower part of the housing
required for the tightness of the housing cannot be damaged during
assembly or disassembly.
12. During the commissioning of the operating equipment for use in
dust, the commissioned parts should be subject to a new piece
inspection.
13. The speaking funnel from the receiver consists of non-conductive
plastic. It may charge up dangerously with high air speed. Thus, it is
forbidden to clean the speaking funnel with compressed air.
14. A rust film can form in case of a high concentration of sulphurous
gases in the air.
15. We reserve the right to modify the product for its technical
development without preliminary notice.

CE symbol

We hereby declare this product is in compliance with the Essential
Health and Safety Requirements of
ATEX Directive 2014/34/EU,
EMC Directive 2014/30/EU,
Low Voltage Directive 2014/35/EU
The product complies with RoHS 2011/65/EU and
the delegated directive (EU)2015/863
The product is compliant with RoHS Regulation 2011/65/EU, the latest
amendment RoHS 2017/2102 and the extension according to
EU Official Journal L 148 page 72-87 without any exception.
The appropriate standards, technical regulations und specifications
you can take from the attached conformity declaration and the
conformity declarations on our Website.
31