Ce Symbol - Eaton Ex ResistTel Instructivo De Servicio

7. The stipulated position of utilisation must be adhered to. The
telephone must be installed on a plane surface only, in vertical
operating position.
8. Magnetic fields with energy technical frequencies can cause a slight
impairment of the listening quality. If this is the case, please ensure
that the telephone is installed at a suitable location.
9. The telephone must be switched off before opening. Wait at least 2
minutes after switching off power before opening the telephone!
10. In the open state of the telephone no dust may ingress the device.
11. Upon mounting or demounting the device, do not damage the cover
seal, which keeps the cover tight, or the collar on the lower part of
the housing.
12. Upon repairing the apparatus for use in dust, the repaired parts
should once again be subjected to a routine test.
13. The mouthpiece horn of the receiver consists of a non-conductive
plastic material. It may become dangerously charged at high air
speeds. Consequently,
pressurized air is prohibited.
14. If there is a high concentration of sulphurous gases in the
environment, the lettering of the keys can fade and a rust film can
arise.
15. Changes to the product which are in the interests of technical
progress are possible even without prior notice.

CE symbol

We hereby declare that this product is in compliance with the essential
health and safety requirements
- ATEX Directive 2014/34/EU, the EMC Directive 2014/30/EU,
- Low Voltage Directive 2014/35/EU
The product complies with RoHS 2011/65/EU and
the delegated directive (EU)2015/863
The product is compliant with RoHS Regulation 2011/65/EU, the latest
amendment RoHS 2017/2102 and the extension according to
EU Official Journal L 148 page 72-87 without any exception.
The relevant standards, technical rules and specifications can be
found in the attached Declaration of Conformity and the Declarations of
Conformity on our website.
cleaning the mouthpiece horn with
33