Control Button - FONESTAR FO-459-TX Manual De Instrucciones

EN
Note: Do not use more than one mobile phone / tablet to control the system simultaneously.
4.2 Router MODE -"Matrix Control Lite" APP
4.2.1 Android user: download the APP "Matrix Control Lite" from google play.
4.2.2 IOS user: download the "Matrix Control Lite" app from the app store.
4.2.3 First, connect the router to the IGMP switch. Then, connect a mobile phone to the router, open
the downloaded APP "Matrix Control Lite" and it will enter the interface as shown in figure 3, TX ID,
RX ID, the connected TX number can be reset by this app, you can also edit the device name to dial.

5. Control button

There is a "TX ID"
on the RX unit.
Each of them consists of two Nixie tubes and two buttons (in addition to the Nixie tube), the left button
controls the value of the left Nixie tube and the right button controls the value of the right Nixie tube. The value
of each Nixie tube is from 0 to 9, each button is pressed at a time, the number is added a value. For example,
the existing value of TX ID is "00", and press the left button once, also press the right button once, then the
TX ID value is changed to "11". When the value of "TX connected" on the RX unit is the same as the value
of "TX ID" on the TX unit, a connection built between the TX and RX units.
Short press: press to configure the IGMP group and display the configured value. The product automatically
switches to the corresponding IGMP group 5 seconds after press.
Long press: press and hold 3 seconds to restart the product.
on the TX unit, and both the "RX ID" and "TX connected'
- 6 -
are