Mx Onda MX-CDP2688 Manual De Usuario E Instalacion página 23

3. Chimney installation
The chimney of the extractor hood is made up of two pieces, which are
inserted one inside the other to adapt to the height between the ceiling and
the main body of the extractor hood.
a) Measure the distance from the main body of the hood to the ceiling.
b) Insert the section of the upper chimney that has ventilation grids inside
the lower section of the chimney (the grids must be visible), and adjust
the total length of the two sections until obtaining the measurement
that there is from the main body of the chimney. hood to the ceiling.
c) Place the assembly between the main body of the hood and the ceiling,
fix the lower part of the chimney using screws A (3.5 x 9.5 mm), see
figure 9.
d) Then fix the upper part of the chimney to support 1 using screws B (3.5
x 9.5 mm), see figure 9.
Figure 7
10
Figure 8