Machine Information - VONROC PS504DC Traducción Del Manual Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
Electrical safety
It must be observed that no liquid may be directed
directly at electrical devices and equipment contai-
ning electrical components. If used incorrectly or if
the batteries are damaged, flammable liquid may be
ejected from the batteries. Contact with this liquid
should be avoided. If contact accidentally occurs,
rinse off with water. If the liquid comes into contact
with your eyes, seek additional medical attention.
• Never open the Pressure Sprayer or unscrew
the nozzle when the Pressure Sprayer is still
pressurised. To prevent injury, never connect the
Pressure Sprayer to an air-compressor.
• Always hold the Pressure Sprayer upright before
the safety relief valve is pulled. When spraying
insecticides, herbicides and fungicides or other
liquid plant protection products, you must
comply with all special precautionary measures
specified by the manufacturer of the product
you are using.
Before opening the tank of the Pressure
Sprayer, thoroughly release pressure by
pulling the safety relief valve.
DANGER! Small parts can be easily swallowed.
There is also a risk that the polybag can suffocate
toddlers. Keep toddlers away when you assemble
the product.
Operational safety
CAUTION: The tank may only be filled with a maxi-
mum of 5 litres liquid.
• Inspect the Pressure Sprayer visually before
each use.
• Never leave your Pressure Sprayer unattended
and do not store for long periods when long
periods when full and pressurised.
• Keep the unit out of the reach of children. You
are responsible for the safety of others.
WWW.VONROC.COM
• Keep your Pressure Sprayer away from heat
sources and hot environments.
• Screw on the pump handle tightly by hand (do
not use tools) and ensure that the O-ring is
positioned correctly.
• The On / Off switch may only be switched to
"I" when the pump handle is screwed on the
container.
• Only charge the battery at an ambient tempe-
rature which is between 0 °C and + 40 °C. If
the temperature of the battery is outside the
permissible charging temperature range, the
battery cannot be charged. As soon as the
permitted temperature range is reached, the
battery is charged.
Cleaning Safety
• Release the pressure after each use, empty the
container, clean it carefully and rinse with clear
water. Then leave the pressure sprayer open and
allow it to dry.
• Do not dispose of residual fluids in the sewerage
system (local disposal systems).
• Always clean the Pressure Sprayer before using
a different product to avoid chemical reactions.
• When using several Pressure Sprayers, the
tanks and spray nozzle may not be exchanged
between them.
Storage safety
• Before storing, loosen the tank cap and always
empty your Pressure Sprayer completely (also
after cleaning with water).
• Store away from frost.
• Carry the pressure sprayer by the carrying strap
or the handle.
• Make sure that the product is protected from
direct sunlight. The product may heat up.

2. MACHINE INFORMATION

Intended use
The pressure sprayer is intended for distributing
solvent-free liquid, for example: pesticides
herbicides
, fertilisers
and window cleaners
1
1
domestic gardens and allotments.
It must not be used in public places, parks, sport
arenas, or in agriculture or forestry. Compliance
with the specifications in this operating manual is
EN
,
1
in
1
7

Publicidad

Tabla de contenido
loading

Tabla de contenido