Machine Information - VONROC PW507AC Traducción Del Manual Original

EN
preventer in the water pipe to prevent dirty
water fl ow back to the drinking water system.
The backfl ow preventer shall comply with EN
60335-2-79 ANNEX AA.

2. MACHINE INFORMATION

Intended use
The high pressure cleaner PW507AC is quick and
effi cient for cleaning vehicles, machines, boats,
buildings, etc. Only clean vehicle engines in areas
in which suitable oil traps are installed.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Input power
Max. pressure water supply
Max. water temperature
Rated fl ow rate
Max. fl ow rate
Rated pressure
Max. pressure
Weight
IP class
Protective class
Lpa (sound pressure)
Lwa (sound power)
Max. LwA (sound power)
Vibration
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. High pressure cleaner
2. On/off switch
3. Water inlet fi lter
4. High pressure hose
5. Water outlet
6. Gun holder
7. Handle
8. Cable holder
9. Spray gun
10. Adjustable spray lance
8
11. Turbo lance
12. Lance extension
13. Cleaning needle
3. ASSEMBLY
Assembly of the handle (Fig. A, B1)
1. Assemble handle (7) as shown in Fig. B1.
2. Tighten the screws.
Assembly of the gun holder and cable holder
PW507AC
(Fig. A, B2)
220-240 V~ 50/60Hz
Assemble gun holder (6) and cable holder (8) as
shown in Fig. B2.
1400 W
12 bar
4. OPERATION
50 °C
5.5 l/min
6.5 l/min
80 bar
110 bar
5.88 kg
IPX5
II
74.6dB(A) K=3dB(A)
88.3dB(A) K=3dB(A)
92dB(A)
2.089m/s 2
Turning on (Fig. A, C)
1. Turn the switch (2) to the "OFF/0" position.
2. Ensure that you have a suitable water supply to
3. Connect lance (10 / 11) and lance extension
4. Connect the high pressure hose (4) to the
5. Check gauze fi lter (3) is clear of any blockage
6. Connect the water supply hose.
7. Check that the hose has no kinks in it.
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
The machine may cause electrical
disturbances when starting.
The motor of this pressure washer will NOT
run. It will only operate when the trigger is
squeezed.
The cleaner must only be used with clean
water; use of unfi ltered water or corrosive
chemicals will damage the cleaner.
If the motor stops and fails to restart, wait
2-3 minutes before restarting. THERMAL
CUTOUT TRIPPED.
feed the pressure washer.
(12) as shown in Fig. C1.
washer as shown in Fig. C2 and connect the
spray gun (9) to the high pressure hose (4) as
shown in Fig. C3.
and assemble on the machine as shown in Fig.
C4.
WWW.VONROC.COM