I Meaning Of The Sensor Led (Depending On The Model); I Removing The Cleaner From The Water - Polaris W Serie Instrucciones De Instalación

2.5 I Meaning of the sensor LED (depending on the model)

LED status
Steady
Flashing

2.6 I Removing the cleaner from the water

• To prevent damaging the equipment, use only the handle to remove the appliance from the
pool.
2.6.1 "LIFT SYSTEM" automated function
The "Lift System" function was designed to facilitate removing the cleaner from the water. It may be activated at any
time, during or at the end of a cleaning cycle.
• If necessary, press and hold the button
When facing the right wall, release the button. The cleaner moves towards the wall (see image
• Or just briefly press the button
• The cleaner climbs the wall and stays at the waterline (see image
• Use the handle to take it out of the water. The cleaner expels water through a rear jet to make it lighter (see
image ).
Blue
Cleaning cycle activated "Spot Clean" function
Cycle in progress, pool
Remote control function
analysis, or finishing
phases
to direct the cleaner towards the required wall, the cleaner pivots.
to move it towards the opposite wall (see image
Green Orange
"Lift System" or
Filter full
activated
N/A
activated
).
00'60''
Off
No current cycle or
error
EN
).
).
12