I Control Using The App - Polaris W Serie Instrucciones De Instalación

3.4 I Control using the app

Before controlling the cleaner with the app, you must:
• Connect the control box to a power outlet,
• Immerse the cleaner in the pool.
3.4.1 Programming and controlling cleaning cycles
From the application:
• Start/stop cleaning;
• View the current cycle's remaining cleaning time (displayed in hours and minutes);
• Increase/Reduce the cleaning time by 15-minute sequences (depending on the model);
• Choose the pre-saved cleaning modes
• The new cleaning mode will take effect for the cleaning cycle in progress and all future cycles.
• The cleaning cycle time may vary depending on the selected settings.
• Schedule cleaning cycles (days and hours) (depending on model); Cleaning cycles may be programmed to repeat,
only one program can be set per day;
• Check the pool's temperature during the cleaning cycle (depending on model);
The cleaner measures the water temperature while operating.
• When the cleaner is at the bottom of the pool, it is normal for there to be a temperature difference
between that measured by the cleaner and that measured by a thermometer placed at the pool's surface
or measured by another appliance.
3.4.2 "Lift System" function for helping to remove the cleaner from the water
• Only activate the Lift System function if the cleaner is in view.
• From the app, press
• Press the arrows to rotate the cleaner left or right.
• When the cleaner is facing the right wall, press the
3.4.3 Remote control (according to model)
The cleaner can be controlled using your smartphone or tablet as a remote control.
• Use the remote control mode only if you have the cleaner within view.
• 2 modes are available for piloting the cleaner (depending on the equipment):
"Joystick mode": Press the icons to move the cleaner forwards and backwards and to turn left or right.
"Kinetic mode": Control the cleaner by tilting the mobile device upwards (backwards movement), downwards
(forward movement), to the left (turn left), to the right (turn right).
• For cleaning a specific area, use the "Spot Cleaning" function (depending on the model): after this function is
activated, the cleaner cleans a 1m² area directly in front of it.
• If the cleaner is relatively slow to respond to an action requested in the app, check the Wi-Fi network
signal, see§ "3.2 I First-time cleaner configuration".
to use the Lift System function (see § "2.6.1 "LIFT SYSTEM" automated function").
button to bring the cleaner to the wall.
EN
18