Instructions For Use; Troubleshooting - Mr. Heater MHE150FAT Instrucciones De Funcionamiento Y Manual Del Propietario

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

INSTRUCTIONS FOR USE

1. Place the product on a firm, level surface.
2. Plug the unit directly into a 120 V AC electrical outlet.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT.
3. Rotate the POWER KNOB clockwise to select between (fan only),
(low heat) or (high heat). LOW position operates the heater at 1000
watts conserving energy and HIGH position operates the heater at a
maximum 1500 watts.
4. Turn the THERMOSTAT KNOB clockwise to the highest setting.
5. When the room reaches a comfortable temperature, slowly turn the
THERMOSTAT KNOB counter-clockwise until the heating element
clicks OFF (the Power Light will not be shut OFF).
6. This is the point at which the Thermostat setting equals the room
temperature. At this setting, the Thermostat will automatically turn
the heater ON and OFF to maintain the selected temperature.
7. Turn the POWER KNOB to OFF and unplug the heater when finished
using.
THERMOSTAT KNOB
Temperature Control
NOTICE: When the heat function is used for the first time, a slight order
may be present. This is normal and should not occur again unless the
heater is not used for an extended period of time.
NOTICE: It is normal for the heater to cycle ON and OFF as it maintains
the preset temperature. To prevent the unit from cycling, you need to
change the thermostat setting.
POWER KNOB
4
Mr. Heater Electric Heater
MAINTENANCE
1. Turn the POWER OFF.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned
with a soft, damp cloth. A mild detergent can be used if
necessary.
4. After cleaning, dry the unit with a soft cloth.
5. Wait until the unit is completely dry before use.
WARNING:
• DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders,
furniture polish, or rough brushes to clean the heater.
This may cause damage or deterioration to the surface
of the heater.
• DO NOT immerse the heater in water.
STORAGE
Store the heater in a cool, dry location when not in use. To
prevent dust and dirt build-up, use the original packaging to
repack the unit.

TROUBLESHOOTING

If the heater will not operate, please check the following:
1. Check if the power cord is plugged into an electrical outlet. If
not, plug in unit to appropriate outlet.
2. Check if electricity to the outlet is working.
3. Ensure power is turned to ON position.
4. Make sure heater is placed on a flat solid surface.
5. See SAFETY FEATURES section for additional information.
6. Turn the THERMOSTAT KNOB clockwise. The heater only
works when the set temperature is higher than room
temperature.
NOTICE: The product is equipped with an overheat safety feature
protector which will switch off the heater in case of accidental over
heating (ex. Obstruction of air intake and outlet grills, motor turning
slowly or not at all).
NOTICE: It is normal for the heater to cycle ON and OFF as it maintains
the preset temperature. To prevent the unit from cycling, you need to
change the thermostat setting.
Operating Instructions and Owner's Manual