IKOHS Chef BOT COMPACT Manual De Instrucciones página 17

MOTOR RESTING TIME
If the motor is overloaded, an error will occur to prevent overheating. The display will show E1.
To avoid this, here are some indications of resting time to allow the motor to cool:
• After using a dough program (23-27), leave the appliance to rest for at least for 15 to 20 minutes. These programs
force the engine a lot, resting time is very important.
• After using the Pulse function, allow the motor to stop for 2 or 3 minutes. Especially if it has been used for the max-
imum expected duration of 1 minute.
• After using the Chop function, let the engine rest for 10 to 30 minutes depending on the use intensity. Avoid mixing
more than 1 or 2 minutes in a row at a speed higher than 6.
• Allow about 10 minutes of rest between two soup programs.
Speeds used per accessory
Motor speed
ERROR MESSAGES ON THE DISPLAY AND REMEDY
• Attention: Motor over-
MESSAGE
loaded or damaged.
• Un-plug, an let the de-
vice cool down for an
SOLUTION
hour. Afterwards, it is
ready for use again.
For example, error display is shown like below:
MAX
90 min
duration
1
2
3
4
5
6
7
8
9
10
E1
• Attention: No pot de-
tected. Please put pot
in place.
• Put pot into place.
2 min
10 min
√ √
√ √
√ √
√
E3
• Attention:
left. Please add water.
• Switch off and add wa-
ter into bowl. Switch on
after temperature insi-
de bowl cools down.
17
4 min
√
√
√
√
√ √
√ √
√ √
√
√
√
E5 END
No water
• End of Program.
• Press knob and return
standby mode.
EN