Using Program Drivers/Microsd Cards; Uploading A Program/Updating Firmware; Upload Program From Program Driver; Upload/Update - Errors - Dr. Clark VariZapper 2.0 Manual De Instrucciones

The VariZapper 2.0

4.1.4 Using Program Drivers/microSD Cards

The microSD Card should be put in the slot with the the PINS SHOWING UP (Fig. 9 and 10). The microSD
Cards have frequencies programmed on them which are put together according to Dr. Clark's frequency
list for their specific purpose. This enables you to use the VariZapper 2.0 with very specific frequencies.
EN
Fig. 9 Fig. 10

4.1.4.1 Uploading a program/updating firmware

The device automatically recognizes whether the microSD Card contains a frequency program or a
firmware update.

4.1.4.1.1 Upload program from Program Driver

Insert the microSD Card only when the Main Menu Panel is displayed (Fig. 11).
IMPORTANT:
Just after the Program Driver (PD) has been put into the slot, the PD will be uploaded automatically and
the message in Fig. 12 will appear, if the upload was successful. To select the uploaded PD press .
You will be able to see and select all the PDs stored on the device (Fig. 13).
Fig. 11 Fig. 12 Fig. 13
4.1.4.1.2 Update firmware with mircoSD Card
To update the firmware with a microSD Card:
1) First turn off your VariZapper 2.0
2) Insert the microSD card with the new firmware, then
3) turn on the device (press the Turnwheel for 5 seconds).
The software is now updated automatically. While the firmware loads, the Turnwheel is lit red. When the
upload is complete, the Turnwheel light turns green.
4) Remove the microSD card, before you restart your updated device.
4.1.4.1.3 Upload/update – Errors
If there is a problem with the upload of the PD, one of 3 different error messages comes up: THE CARD
IS BLANK (Fig. 14), THE CARD IS DAMAGED or NOT A SOFTWARE OR PD CARD. In this case remove
the card and select .
Fig. 14
6
Anleitung_VariZapper2018_all language.indd 7 19.05.2018 03:10:28