Quick Code Reference; Problem & Solution - One for All URC-3435 Manual De Instrucciones

Quick Code Reference

Write down the codes for your devices in the boxes below and in
the battery compartment for quick and easy reference.
Device Type
1._________________________
2._________________________
3._________________________
Problem & Solution
Problem:
Your brand is not listed
in the code section?
The ONE FOR ALL 3 does
not operate your
device(s)?
The ONE FOR ALL 3 is not
performing commands
properly?
Problems changing
channels?
Video not recording?
The ONE FOR ALL 3 does
not respond after
pressing a key?
The red light does not
blink when you press
a key?
10
Code
I I I I I I I I
I I I I I I I I
I I I I I I I I
Solution:
Try the search method on page 7.
A) Try all the codes listed for
your brand. B) Try the search
method on page 7.
You may be using the wrong
code. Try repeating the Direct
Set-Up using another code listed
under your brand or start the
search method over again to
locate the proper code.
Enter the programme number
exactly as you would on your
original remote.
As a safety feature on your ONE
FOR ALL 3, you must press the
Record key twice.
Make sure you are using new
batteries and are aiming the one
for all at your device.
Replace batteries with 2 fresh,
new "AA" alkaline batteries.
WWW.ONEFORALL.COM