Jocel JTDSZF20LJ-80L Manual De Instruciones página 23

USER'S REQUIRED READING
− Jocel won't load any responsibilities to this electric water heater's inappropriate
installation.
− Before installing and using the electrical water heater, please careful1y read the entire
instructions. If not following the required methods in this instruction brochure lo make
installations or use it, it may cause the severe hazard accidents and the property
losses.
− Before opening the electrical water heater's any covered decks or doing some
cleaning and mending to the electrical water heater, please make try to pull away the
power-source plug first.
THE OPERATING COMMON KNOWLEDGE
− Before operating it each time, you must make sure the electrical water heater is filled
with water first. After that, you can put through the power source.
− When no tap water provides, you mustn't use the water in the tank of electrical water
heater.
− For the cold and frozen regions in winter, when not using it for a longer period of time,
you should make the water in the tank of electrical water heater empty.
The emptiness-making method refers to "Security Characteristics" in this instructions
brochure.
− When the electrical water-heater is in normal work, the pressure- leakage mouth of
the security valve may exist the water drops to drip out. This belongs to the normal
conditions. Take care not to block this pressure - leakage mouth.
You can use the plastic pipes to lead flowing. However, you must keep it through with
atmosphere.
− The power-source outlet must have the reliable ground connections for the use.
− Double-level Temperature-limiting Protection Switch: This electric water heater
possesses one required artificial position-resetting double-level temperature-limiting
protection switch. Enabling to automatically cut off the power sources when the
electrical water heater is over-heat by the accidents or the water temperature is too-
high. Guaranteeing the two poles are cut off. That ensures to be safe.
− The Position-resetting Methods of the Double-Position Temperature-limiting Device:
I) Pull down the power-source plug
2) Make the plastic lid on the right side of the electrical water-heater to be opened with
tools.
3) Press down the white-color position resetting button on the two-positional
temperature limiter.
4) Close the plastic cover.
5) Slightly reduce the temperature-setting value.
6) Reinsert the plug of the power source and put through the power source.
All manuals and user guides at all-guides.com
-22-