Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
−
Water Entering: After fixing ali the pipes, then make the cold and
heat water-blending valve rotate to the high temperature sector
according to the clockwise direction. And reopen the old water
pipe's water entering valve. At this time, the electrical water
heater's tank will start to enter the water. Waiting that the shower
sector of the water exiting mouth is in normal condition, which
indicates that the tank has full filled with water.
Cautions: During the electrical water heater is in the normal
operating procedures, the water-entering valve of the cold water
pipe's mouth-entering sector must be in the open condition from the
beginning to the end. At this time, the water-entering valve can still make the functions
of regulating the water-existing mouth section's flowing strength and weakness.
However, the cold and hot mixed water valve can only regulate the water temperatures
and make the function of closing the water exiting.
− Putting through the power: After confirming the tank to be fully filled the water, you can
make the power source's plug into the outlet and put through the power sources.
− Hot water operations: After the electrical water heater normally works and the heats for
a long period of time, you can use the hot water in the tank, you need to make the cold
and hot mixed valve rotate with the clockwise direction slow fly from the low
temperature to the high temperatures in the closed condition. And adjust it to your
proper temperature. At that time, the shower mouth can come out the hot water. After
finishing the uses, you can turn it to the closed section by the anti-clockwise direction
and shut off the mixed water valve.
Cautions: When adjusting the water temperature of the water-exiting mouth, you don't
make the shower directly to the human body; you should test the water temperature
first to avoid burning to damages.
− Overheating Protections: Under the condition of putting through the power, but the
heating pipe won't heat from the beginning to the end. That means the two power-
selecting switches will be in the putting through position. At this time, it may appear the
overheat protections (that is to make functions by the double-positional temperature-
Iimiting protection switch).
− Automatically balance the temperatures: When the water temperature in the tank
reaches the set one, it will automatical1y cut off the power and halt heating. Meanwhile,
the heating indicator will put out. The electrical water heater will be in the temperature-
maintaining condition. When the water temperature in the tank reduces to a certain
one, it will automatically begin to heat. After reaching the temperature, it will
automatically cut off the power and be in the temperature-keeping condition.lt will
circulate to automatically work like these.
− Notes: If the power wire damaged, it must be changed by professional man from the
manufacturer or maintenance center.
All manuals and user guides at all-guides.com
-27-
Publicidad
Tabla de contenido
