Bayco SL-868 Manual De Instrucciones

Instruction Manual
SL-868
THANK YOU FOR PURCHASING THE SL-868 LED WORK LIGHT W/ MAGNETIC
BASE ON RETRACTABLE REEL. PLEASE SAVE THESE INSTRUCTIONS.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR WORK LIGHT.
ELECTRICAL RATING - 125 VOLTS 60 HZ
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK AND FIRE - PULL PLUG
WHEN SERVICING THE CORD REEL.
CAUTION
y DO NOT use this cord reel in explosive atmospheres, near flammable liquids, or
where explosion proof lamps are required.
y DO NOT use in the proximity of vehicles or equipment when there is a risk of
flammable liquids coming into contact with the hand lamp
y DO NOT immerse in water
y DO NOT use in areas where water can accumulate or in rain or mist
y CAUTION: Risk of Electric Shock – For Light Duty Dry Location Use Only
y GENERAL USE CORD REEL ONLY. NOT FOR HARD USE. FOR INDOOR DRY
LOCATION USE ONLY FOR LIGHT DUTY RESIDENTIAL USE ONLY
WARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONS
CAUTION: DO NOT USE IN HAZARDOUS LOCATIONS AS REQUIRED BY THE
CANADIAN ELECTRICAL CODE, PART I
IMPORTANT SAFETY INSTRUCTIONS
y This product has a 3 prong polarized plug on the power cord. Do not attempt to
bypass this safety feature by removing the round plug and defeat his safety feature.
This plug will fit into a grounded outlet only one way. If the plug does not fit fully into
the outlet, contact a qualified electrician. Never use with a two wire extension cord.
y CAUTION: Drywall will not hold the weight of the reel assembly
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.mybayco.com
All manuals and user guides at all-guides.com
y CAUTION: Read and understand mounting instructions before attempting installation
and use of this product
MOUNTING
Ceiling or Wall Installation
y Select a location within 2 feet of an electrical outlet. The outlet for a garage door
opener is desirable.
y Drywall will not hold the weight of the reel assembly, so locate a ceiling joist or
wall stud and using the mounting bracket as a template, mark the holes so they are
centered on the ceiling joist or stud.
y Attach the mounting bracket to the stud using the 2 wood screws provided.
y Align the holes on the side of the reel with the holes in the side of the mounting
bracket and insert the pin.
y Place the retaining ring on the pin and twist until the entire ring is through the hole in
the pin. DO NOT operate this reel without the retaining ring in place on the pin.
SAFETY / CARE
Reel
y CAUTION: Do not allow the cord to retract by itself as damage or injury may occur
from excessive rewind speed.
y Adjust the cord stop to hold the receptacle at the desired length when the cord is
retracted.
y Before cleaning the reel always unplug from the power source.
y Clean the outside of the cord reel only. Use a soft cloth with mild detergent. Do not
use petroleum based to clean the cord reel. Never immerse the cord reel or receptacles
or work lights in water. Dry thoroughly before attempting to reattach to power source.
Work Light
y Lighted lamp may become hot!
y Light can be used indoor and outdoor.
y Check that the sealed push button switch is in the off position before plugging in the
work light
y Connect light to 120Volt, 60 Hz power source only.
y Do not touch hot lens, or enclosure.
y Do not remain in light if skin feels warm.
y Do not look directly at lighted lamp, or direct the light at other persons.
y Keep lamp away from flammable materials.
y Use this light only when attached securely to a metal surface capable of supporting
the product's weight.
y Do not use the magnet as a floor stand.
OPERATION
CAUTION: BECAUSE THE SL-868 HAS A MAGNETIC BASE, IT IS LIKELY
THAT IT WILL BE PLACED IN AN ELEVATED POSITION ABOVE THE GROUND.
THEREFORE CAUTION SHOULD BE USED TO BE CERTAIN THAT THE MAGNET
IS SECURELY ATTACHED TO THE METAL SURFACE BEFORE RELEASING THE
LIGHT. IT IS ALSO ADVISED THAT EXTRA CARE BE TAKEN WHEN ADJUSTING
OR MOVING THE CORD SO THAT THE WORK LIGHT DOES NOT COME LOOSE
AND FALL TO THE GROUND.
INS-SL-868-16