Storage - EMAK BT 4000 Guía De Utilización

d) Stopping the motor
Wait until the shredder is empty before stopping it as plant matter left in the feeding chute or blade casing
could jam the rotor when restarting the machine.
SUBARU EP 17
Warning: because of rotor inertia, the stop time is relatively long.
e) Unblocking obstructions (wear gloves)
- Disconnect the spark plug cable.
- Remove branches from the feeding chute.
- Completely unscrew the lever of the obstruction clearance hatch.
- Slightly pivot the door so that you can pull it and then fully pivot downwards.
- Clear all the plant matter jamming the shredder
(check there is no plant matter in the feeding chute and discharge chute).
- Close the hatch (follow instructions in reverse). make sure the lever is fully screwed back down.
(Impossible to restart the shredder if the lever does not press on the contact switch).
- Disconnect the spark plug cable.
- Close off the fuel inlet pipe.
- Loosen the 4 m8 nuts holding the feeding chute while ensuring they remain threaded to the captive
screws.
- Lift the feeding chute so that the nuts pass through the flange then pull it off.
- Replace the protection hatch and tighten the 2 nuts.
- Place the feeding chute in its holder using the handle.
1
VII / STORAGE
12 - EN
2