Tools Required For Assembly - Bergstrom SLIM FIT BMC TGR 1846 Instrucciones De Montaje

SLIM FIT
or, although it has a hatch, the material is not
resistant enough (if roof is made of fibre, plastic,
etc...), it is the installer who will have to decide,
under his responsibility, if it is necessary to
reinforce the roof to avoid possible deformations,
breaks, water entries, etc., habilitating the means
required to stop it from occurring.
- Important: When connecting the unit make sure
the polarities are not reversed. If this happens, the
control board will not switch on and the unit will
not operate.

Tools required for assembly

- Torx wrenches set
- Allen wrenches set
- Open-jawed spanner 13, 14, 22
- Scissors
- Flexo-meter
- Screwdriver
Proper use of the product
- SLIMFIT is a roof-mounted air conditioning unit
suitable only for use in trucks. It is not suitable
for installation and operation in agricultural
or construction machinery subject to intense
vibrations.
- The unit does not comply with ADR regulations.
- Non-intended use will void the unit's warranty and
exempts the manufacturer from any responsibility.
- If you are not sure how to use SLIMFIT, read the
product's user manual.
- If the temperature in your vehicle's cab is too
high for rest, first cool the cab with your vehicle's
air conditioning for a few minutes and then run
SLIMFIT to maintain the comfort temperature.
Associated documentation
- Quick guide: 220AA64060
- User manual: 220AA35378
- List of spare parts: 1003097515
- Troubleshooting: 220AA35379
Dirna Bergstrom declares that the SLIMFIT unit
complies with the requirements of the following EC
Directives and that the harmonised standards and
technical specifications listed below have been
applied:
- EC Directive 2014/53/EU
- EC Directive 2011/65/EU
- EC Directive 2014/30/EU
21
EN