Remote Control Operations; Installing The Battery - Advent SB7 Manual Del Usuario

All manuals and user guides at all-guides.com

Remote Control Operations

Installing the Battery

Before attempting to operate your remote
control, install the batteries as described
below.
1. Turn the remote control face down.
Press down on the ridged area of the
battery cover and slide it off .
2. Install two "AAA" batteries as shown.
Make sure that proper polarity (+ or -) is
observed.
3. Slide the cover back until it clicks.
The remote control will only operate this
device. It is not a universal remote control
and will not control other equipment.
Warning/Caution on Using Batteries
• Always ensure that the batteries are
inserted with the positive and negative
terminals in the correct direction as
shown in the battery compartment.
• Diff erent types of batteries have diff erent
characteristics. Do not mix diff erent types.
• Do not mix old and new batteries. Mixing
old and new batteries will shorten battery
life and/or cause chemical leaks from the
old batteries.
• When batteries fail to function, replace
them immediately.
• Keep the batteries out of the reach of
children. Should the batteries be swal-
lowed, immediately consult a doctor. Also,
when disposing of used batteries, please
comply with governmental regulations
or environmental public institution rules
that apply in your country/area.
• Remove the batteries if the remote
control is not used for a month or longer.
Remote Control Operations
EN
13