The Learning Feature; Remote Onto The One For All 5) - One for All URC-7950 Guia Del Usuario

All manuals and user guides at all-guides.com

The Learning Feature

(How to copy functions from your original working remote
onto the ONE FOR ALL5)
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your ONE FOR ALL, nor your original remote control
is pointing at your device.
Example: To copy the "mono/stereo" function from your original TV
remote onto the "Red"key of your ONE FOR ALL 5.
1 Place both remote controls (the ONE FOR ALL 5 and your
original) on a flat surface. Make sure the ends which you
normally point at your device are facing each other. Keep
the remotes at a distance of 2 to 5 cm.
2 Press and hold down the M (MAGIC) key
until the red LED underneath the POWER key
blinks twice (the red LED will blink once
then twice).
3 Press 9 7 5 (the red LED will blink twice).
4 Press the device key (on the ONE FOR ALL remote) to
select the mode to which you want to copy the learned
function (Example: TV key).
5 Press the key (on the ONE FOR ALL remote)
where you want to place the learned function
(Example: "Red" key). The red LED will
flash rapidly.
6 Press and hold the key (on your original remote)
that you want to copy until the red LED blinks twice
(Example: "mono/stereo" key).
7 If you want to copy other functions within the same mode, simply
repeat steps 5 and 6 pressing the next key you want to copy by
learning.
8 To exit the learning mode, press and hold down
the M (MAGIC) key until the red LED blinks twice.
9 Learning is mode specific. To access your learned function,
press the appropriate device key first.
Important notes:
- The ONE FOR ALL 5 can learn approximately 25 – 40 functions.
- You can replace a learned function by placing another learned function
on top.
- Upon changing the batteries, your learned functions will be retained.
8
x2
WWW.ONEFORALL.COM