Skil 1558 Manual Original página 7

Operating the tool
-
- place tool on workpiece
! ensure that only the front shoe rests on the
workpiece and that the knives do not touch it
-
switch which cannot be locked) and then pulling
trigger J
!
should run at full speed
!
coloured grip area(s)
-
forward in a continuous stroke
- use the tool with its base-plate on the workpiece
- do not tilt the tool in order to avoid unwanted planing
marks
!
from the workpiece
-
APPLICATION ADVICE
For chamfering edges use the V-groove in the front shoe
- set knob D to position "0" for chamfering edges similar
to groove
- for larger grooves turn knob D to select the required
planing depth
!
MAINTENANCE / SERVICE
This tool is not intended for professional use
Always keep tool and cord clean (especially ventilation
slots L )
!
If the tool should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for SKIL
power tools
- send the tool undismantled together with proof of
purchase to your dealer or the nearest SKIL service
station (addresses as well as the service diagram of
ENVIRONMENT
Do not dispose of electric tools, accessories and
packaging together with household waste material
(only for EU countries)
- in observance of European Directive 2002/96/EC
on waste of electric and electronic equipment and
its implementation in accordance with national law,
electric tools that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility
- symbol will remind you of this when the need for
disposing occurs
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in conformity with the following standards
EN 55014, in accordance with the provisions of the
(= safety
directives 2004/108/EC, 2006/42/EC, 2011/65/EU
4825 BD Breda, NL
NOISE/VIBRATION
Measured in accordance with EN 60745 the sound
pressure level of this tool is 90 dB(A) and the sound
The vibration emission level has been measured in
accordance with a standardised test given in EN 60745;
it may be used to compare one tool with another and as
a preliminary assessment of exposure to vibration when
using the tool for the applications mentioned
-
increase the exposure level
-
reduce the exposure level
!
keeping your hands warm, and organizing your
work patterns
INTRODUCTION
Cet outil est conçu pour le rabotage des matériaux
en bois, tels que des poutres et des plances; il est
également approprié pour chanfreiner
Cet outil n'est conçu pour un usage professionnel
Lisez et conservez ce manuel d'instruction
SPECIFICATIONS TECHNIQUES
A Rangement pour la clé
B
C
D Bouton de réglage de la profondeur de rabotage
E Indicateur de la profondeur de rabotage
F Adaptateur de l'aspirateur
G Evacuation copeaux
7
1558