During Use; After Use; Before Use - Skil 1840 Manual Original

4) POWER TOOL USE AND CARE
Do not force the power tool. Use the correct power
tool for your application. The correct power tool will do
the job better and safer at the rate for which it was
designed.
Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
the risk of starting the power tool accidentally.
Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc., in
accordance with these instructions, taking into
account the working conditions and the work to be
performed.
from those intended could result in a hazardous situation.
5) SERVICE
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
SAFETY INSTRUCTIONS FOR ROUTERS
GENERAL
16 years
making any adjustment or changing any accessory
ACCESSORIES
when original accessories are used
at least the highest no-load speed of the tool
router bits with this tool

BEFORE USE

you start working
a rating of 230V or 240V can also be connected to a
Do not work materials containing asbestos (asbestos
Use clamps or another practical way to secure and
support the workpiece to a stable platform (holding
ear protection
(contact with or inhalation of the dust may cause allergic
reactions and/or respiratory diseases to the operator or
wear a dust mask and work with a dust
extraction device when connectable
work with a dust extraction device when
connectable
materials you want to work with

DURING USE

Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord (cutting
switched on
cutting
to a standstill

AFTER USE

tool
in the cord of this tool to the earth terminal of the plug
it must be disposed of safely and not left unattended
USE
! switch off the tool and disconnect the plug
! ensure that router bit shaft is perfectly clean
8
wear a dust mask and
2
2
4