2. FRONT VIEW
(1) GENERAL FAULT indicator light.
Yellow LED system alarm indicator.
(2) SYSTEM FAULT indicator light.
Yellow LED internal equipment error indicator.
(3) EMERGENCY indicator light.
Red LED emergency indicator. Remains illuminated while
the system is in Emergency Mode.
(4) POWER indicator.
Indicates that the unit is receiving power.
3. REAR VIEW
1) 100-240V AC 50/60 Hz Power supply input. Male socket
CEE22 for connection to the mains supply by means of
the cable supplied together with the IF-702ETH.
2) Mains fuse (3.15A). There is also a spare fuse in the same
box.
3) ON/OFF Switch. Switch for turning on the equipment. If
the IF-702ETH is operating by secondary power supply
(24VDC input), this switch has no effect.
IF-702ETH version 5.0.001
IF-702ETH
Figure 1
(5) Buzzer.
The IF-702ETH incorporates a buzzer that generates an
acoustic signal when an alarm is received.
(6) Internal jumper for deactivating the acoustic alarm in
SYSTEM FAULT errors.
(7) CONSOLE connector.
Mini USB connector Allows monitoring the system. Only
specialised personnel.
(8) Front USB for inputting music.
Figure 2
4) Battery holder. See section 4.
5) IP Connection, communication and control module. See
section 3.1.
6) Audio outputs module. See section 3.2.
R+D Department
IP Audio interface
2 outputs
5