Fitting And Removing The Fl Ange; Removing Fl Ange; Fitting Fl Ange - Sicam SBM V655 Manual Original

5. Fitting and removing the
flange
Fitting of the flange is necessary in the following situa-
tions:
+
Commissioning
+
When changing the type of flange
(universal - 3/4/5 hole)
+
When changing the type of wheel
(passenger car - motorcycle)
!
Balancing accuracy will be impaired if the flange has
not been properly fitted to the shaft.Before fitting the
flange, clean and degrease (remove corrosion protec-
tion) the cone of the shaft and the flange opening.
5.1 Removing flange
i
The SBM V655 must be switched on.
1. Press the pedal.
« This blocks the shaft.
2. Slacken off the hexagon socket head bolt.
3. Unfasten the flange by tapping with a rubber-headed
hammer on the cone end.
4. Pull the flange off the cone.
"
Flange detached.
Sicam srl società unipersonale
All manuals and user guides at all-guides.com
Fitting and removing the fl ange | SBM V655 | 33
5.2
i
1. Press the pedal.
2. Slide the flange onto the shaft.
3. Tighten the hexagon socket head bolt.
"
Fitting flange
Clean and degrease the cone of the shaft and the
flange opening.
« This blocks the shaft.
Flange fitted.
en
|
656 234 2010-11-22