Technical Specifications - Vivanco FMS 3000 Instrucciones De Uso

Explanation of the functions
Auto-tuning
If you are picking up interference, set the channel selection switch on the transmitter to
the second channel. Then press the channel selection button 'Scan' on both RF speakers
and they will switch over to the new broadcasting channel.
Wall mounting
The RF speakers can also be mounted on the wall. Observe the distance between the
holes on the reverse side of the speakers.
Fold-out feet
Fold out the feet to ensure that the speaker has a stable base.
Stand-by mode
The transmitter switches off automatically if it receives no audio signal over an extended
period.
When a new audio signal is received, the transmitter switches on again automatically.
Using batteries or rechargeable batteries
RF speakers (the standard delivery does not include batteries or rechargeables)
1. Open the battery compartment by removing the lid.
2. Insert the batteries or rechargeable batteries (micro, type AAA) into the battery
compartment, observing the correct polarity.
3. Replace the lid of the battery compartment.
Disposing of the batteries and rechargeable batteries
Consider the environment when disposing of the batteries or rechargeable batteries,
which must not be thrown away with domestic rubbish. Do not use old and new batteries
or different battery types simultaneously. Remove batteries from the device if it is not to
be used for a long time.

Technical specifications

Frequency range:
Power supply:
Transmitting power:
Operating Temperature:
Subject to alteration!
Trouble-shooting
If your device should not function properly, please proceed as follows:
1. Using the following table of malfunctions, try to find and correct the fault.
2. Read the corresponding section in these instructions carefully.
6
All manuals and user guides at all-guides.com
GB
863-865MHz
Transmitter: Plug-in power supply unit
12 Volt DC / 200mA
Rf-speakers: Plug-in power supply unit
12 Volt DC / 500mA
or 6 x AA batteries (optional)
max. 10 mW
5 - 40° C
GB
3. Look on the Internet at www.vivanco.com to see whether the fault and its correction
are described.
4. Ask your dealer.
5. Call the telephone hotline 01805 / 40 49 10 (€0.14/min.) for Germany - charges may
vary when calling from a mobile phone). You will find contacts for Europe at
www.vivanco.com
Problem Possible cause
No transmission / no sound Devices are outside range
Batteries are empty
Connection cut off
No signal is being received by the
transmitter's input station – the
green reception display does not
light up.
Incoming signal not loud enough
A noise can be heard in the signal Channel suffers from interference.
Batteries are almost empty
Devices are on outer margin of
range
Position of transmitter
Licence
This Vivanco RF product conforms to the European R&TTE directive for RF systems in
harmonised frequency ranges. These systems may be sold and operated in the EU and in
EFTA countries.
Operation is not permitted in any countries not named.
The declaration of conformity is included at the end of this manual.
Warranty
The warranty period is 24 months from the date of purchase.
Hotline
Contact Germany:
European contacts can be found at http://www.vivanco.com.
GB
Solution
Reduce distance between devices.
If ordinary batteries are used, replace them.
Check whether or not all plugs are correctly plugged in.
Start the music on your audio source.
Increase the volume of the music signal.
Change the channel with the help of the auto-tuning function.
The batteries are almost empty and need to be replaced.
Transmitter and RF speaker are too far apart. Bring the radio
headset closer to the transmitter.
In some cases it may be necessary to place the transmitter
somewhere else or higher.
Telephone hotline 01805 / 404910 (0.14 € / min. - charges
may vary when calling from a mobile phone).
or http://www.vivanco.de.
7