Cub Cadet CC1-PH Manual Del Operador página 7

WARNING:
Before using any attachment, read and
understand the manual that came with the attachment.
Follow all safety information contained within.
OPERATING THE COUPLER
The coupler enables the use of various optional attachments.
Installing the Attachment
1. Remove the protective cap from the attachment.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen the coupler (Fig. 4).
4. Align the release button with the guide recess (Fig. 5).
5. Push the attachment straight into the coupler until the release
button snaps firmly into the primary hole (Fig. 5).
6. Turn the knob clockwise to tighten the coupler (Fig. 4).
NOTE: Do not tighten the nut (Fig. 5).
CAUTION:
Before operating the unit, make sure the
release button is fully snapped into the primary hole and the
knob is securely tightened.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler (Fig. 4).
3. Press and hold the release button (Fig. 5).
4. Pull the attachment straight out of the coupler (Fig. 3).
Coupler
Tighten
Knob
Primary Hole
Nut
7
Attachment
Fig. 3
Loosen
Fig. 4
Release Button
Guide Recess
Fig. 5