AIRROBO P10 Manual De Usuarios página 8

（正式版）1210200241 P10 扫地机器人英德法意西俄说明书_20211228.pdf 8 2021/12/29 10:41:16
Part 3 Installation and operation
3.1 Connect the charging base
Assemble the charging base and switch on the adaptor.
Place the charging base close to a wall and remove obstacles approx. 1 M on both sides and approx. 2 M in front of the robot vacuum
cleaner. The signal light on the charging base should be on.
3.2 Charging the robot vacuum cleaner for the first time
A. Direct charging
Plug the adapter directly into the DC jack on the side of the robot vacuum cleaner, connect the other end of the adapter to the power supply.
B. Charged by charging base
C
Place the robot vacuum cleaner on the charging base to charge, making sure that the contact points are aligned with the charging base.
M
Y
CM
MY
CY
CMY
K
To better maintain the battery life:
• Charge the robot vacuum cleaner for 4-6 hours before use. When fully charged, the indicator will stop blinking.
• During the normal use, the robot vacuum cleaner will automatically come back to its charging base, connected to the power supply, to
charge.
• If the robot vacuum cleaner will not be used for a long time, please turn off the power after it is fully charged and place it in a dry and
cool environment. Please charge it every three months to avoid irreversible damage to the battery.
Notes:
• Before use, remove the protective strip on the bumper to guarantee normal product use.
• T h e p o w r e s
• Do not use the robot vacuum cleaner in a suspended environment. If you must use it in a suspended environment, please prevent it
from accidentally falling with firm protective fences, as it may cause personal injury or property loss.
• The robot vacuum cleaner will automatically return to the charging base when the battery runs low.
Power switch
A
w i c t h s i o n h t e s d i e f o h t e o r b t o v a c u u m c e l a n e , r p e r s s " I " o t u t n r t i o , n
-4-
B
a n d p e r s s " O " o t u t n r t i o . ff