Publicidad
Idiomas disponibles
Idiomas disponibles
2-1. With the help of an assistant, and taking extreme caution not to
damage the front of your television, lay the TV face-down on a
flat, level, and very soft surface. You may want to use soft
blankets or towels to cushion the face of the TV. Make sure the
outer frame of the television is supported, and that no pressure is
applied to the screen of the TV.
2-2. Locate the mounting holes on the back of your TV. Place the
Vertical Plastic Interior Bars (A3) over the mounting holes in your
TV as shown in Fig. 20 and center vertically. If mounting the
soundbar ABOVE the TV, the small round bumps on the Plastic
Interior bars should be on the
your soundbar BELOW the TV, they should be on the
2-3. If mounting the soundbar BELOW the TV, place the Vertical Metal
Exterior Bars (A2) over the Vertical Plastic Interior Bars (A3) with
the protruding screws toward the
mounting ABOVE, place the Metal Bars with the screws toward
the
of the TV as shown in Fig. 22.
2-4. Select from the included hardware kit (Silver) the best Washers
and Screws to fit your model television's mounting holes. You
may need to try several to find the right fit. Make sure the Screw
you select fully inserts through both vertical arms and into the
hole. If it does not go in all the way, select a slightly shorter
Screw from the hardware kit. (Fig. 23)
2-5. Insert the four Screws with Washers through the Interior (A3) and
Exterior (A2) Bars and partially screw into the mounting holes on
the back of your television as shown in Fig. 23. Do not yet fully
tighten, allow the Vertical Metal Exterior Bars (A2) to slide up and
down the TV as needed to find the correct fit later.
side of both bars. If mounting
side.
as shown in Fig. 21. If
9
Publicidad
