Mounting; Volume Control; Pre Setting Information; Connecting To The Web Interface - Optimus AT-M15SIP Manual De Instalación Y Funcionamiento

AT-M15SIP
SIP CEILING SPEAKER
2. MOUNTING
Cut out the size of the hole. Use a cardboard template or a circular cutter adjusted to the required
size.
Pass the wires through the hole.
Connect the wires.
Insert the speaker into the ceiling and fix it as shown in the following image.
3. VOLUME CONTROL
The volume of the equipment can be controlled from the SipManager software or the web server.
4. PRE SETTING INFORMATION
AT‐M15SIP can be set from SipManager software or from the webserver. This manual refers to
webserver configuration only.
Webserver is shared among some equipment of the same series, so few menus are unused in this
device.
5. CONNECTING TO THE WEB INTERFACE
The unit's webserver can be accessed by inputting IP address in web browser address field.
The default IP address of the device is 192.168.1.101 The IP address of the computer must be in the
same IP segment to allow the connection.
Note: If the input IP address is found to be incorrect or unknown. You can use the software
SipManager to search, confirm or modify it if necessary.
AT-M15SIP Version 1.0 Page 4 of 16