SNOWJOE SUNJOE 24V-HCSWP-LTE Manual De Instrucciones página 11

2. Latch the locking latch over the hook on the end of the
handle, then press the latch lock down to secure the
connection (Fig. 7).
Fig. 7
Latch lock
3. Slide the removable battery compartment and battery into
the end of the pole assembly, until it clicks into position
(Fig. 8).
Fig. 8
Removable battery
compartment + battery
4. To disassemble the pole pruning saw, press down the
locking button on the removable battery compartment and
slide it out of the pole assembly (Fig. 9).
Fig. 9
Locking button
5. Flip up the latch lock and locking latch to unlock the saw
handle (Fig. 10), then press the locking button on the
bottom of the pole assembly and slide the pruning saw out
of the pole assembly (Fig. 11).
Locking latch
Pole assembly
Pole assembly
Fig. 10
Fig. 11
Locking button
Preparation
Adjusting Chain Tension
m
WARNING!
Use protective gloves when handling the
bar and chain.
1. Make sure the pruning saw is off and the battery is
removed.
2. To tighten the chain, turn the tensioning wheel clockwise
until you meet some resistance. Prior to use, a cold chain
should have no slack on the underside of the guide bar,
while still allowing you to rotate the chain by hand without
binding. Be aware that a chain tensioned while warm, may
be too tight upon cooling. (Fig. 12).
Fig. 12
Tensioning wheel
11
Latch lock Locking latch
R