Velleman HQ-Power VDP2301RGVLD10 Manual Del Usuario página 8

VD P2 3 0 1 RGVLD 1 0 - VD P2 6 0 1 RGYLD 1 0 - VD P3 8 0 1 RGVLD 1 0
•
To start a new configuration, select N e w Con fig; to adjust and existing configuration, click Loa d Con fig.
Select the desired file in the pop-up window.
Globa l da t a :
•
Set the DMX base address of the laser projector between 1 and 511.
When multiple laser projectors are linked, and they must produce the same output, their addresses must
be set to the same value a n d their CON FI G.D AT files m u st be identical.
If they are controlled individually, their addresses must be separated by 16 as each device needs 16 DMX
channels. So the first should be at 1, the second at 17 the third on 33 and so on.
D M X- Ch a n ne ls 1 - 1 6 :
•
Define the DMX channel numbers to control the laser animation. Every function must have a unique
channel number (1~16).
•
Except for the first two parameter (sh ow se le ct L and sh ow se le ct H ) all parameters can be set to a
fixed value by checking the n on e -box and entering the desired value in the dropdown box behind the
parameter or in the showtable below the parameters. In this case, the parameter can not be changed via
DMX anymore.
•
The Sh ow Se le ct H parameter can be set to none by checking the checkbox. By doing this, only the first
16 files in the showtable are accessible.
sh ow se le ct L
sh ow se le ct H
Spe e d Kpps
Fr a m e r e pe a t
pr oj e ct ion size
offse t X
offse t Y
Bla n k sh ift
I n t e n sit y
11/08/2011
Select one of the first 16 shows on the card (including pause). Each show occupies
16 DMX values.
Select one of the 16 banks of shows, each bank containing 16 shows (total=256
shows). A bank uses 16 DMX values.
Set the frame drawing speed (Kpps).
N ot e : this setting might influence the bla n k sh ift setting.
Control the animation speed.
Change the size of the projection (se e im por t a n t n ot e be low ).
Changing the size too fast will result in a 'jumping' display.
0 = maximum negative offset
128 = centre position
255 = maximum positive offset
N ot e : projected display might 'jump' due to the slow DMX signal rate
0 = maximum negative offset
128 = centre position
255 = maximum positive offset
N ot e : projected display might 'jump' due to the slow DMX signal rate
Control the laser off-time between non-consecutive points of the frame.
Control the intensity of the laser output.
8 ©Velleman nv