Preparation For Operation - Expondo Fromm & Starck STAR DESK 24 Manual De Instrucciones

3.2.

Preparation for operation

POSITIONING OF THE UNIT
Keep the unit away from any hot surfaces. The surface on which the desk will be
placed must be even, stable and sufficiently strong.
INSTALLATION
STEP 1: Adjusting the crossbar
- Prepare a large enough surface to allow for convenient and safe installation of the
unit.
Placing all the parts of the product on a cardboard pad or other material to protect
the floor and mounting components from damage is recommended.
- Carefully place the tabletop (not supplied) with the bottom side facing up.
- Place the crossbar (A) on the table top.
- Loosen the hex socket screws that secure the adjustable crossbar elements (do not
remove the screws completely). Slide the adjustable crossbar piece out until the
mounting holes are visible.
Caution: The figure shows the rear side of the crossbar. Make sure the crossbar
remains facing downward during installation.
STEP 2: Installing the lifting columns
- Loosen the screws on the lifting columns (C)/(D).