Installing The Filter System - Renfert POWER steamer water softener Guia De Inicio Rapido

4 Startup
⇒ Remove the equipment and accessories from the package.
⇒ Check the delivery for completeness (compare with the scope of delivery).
Required batteries (2x AA) are not included in the scope of delivery.
4.1

Installing the filter system

Only use the hoses and adapters provided.
A shut-off valve, e.g., a water faucet, must be installed upstream of the filter system.
The filter system can also be operated either free-standing or on its side without being secured.
Vertical wall mounting is recommended.
⇒ Before the filter system is put into operation, the consumer unit supplied must be free from limescale.
⇒ Determine a suitable location for installing the filter system:
- The location of the system must be frost-proof and protected against direct sunlight.
- There must be sufficient space under the filter head for installation of the filter cartridge.
► Determining carbonate hardness
⇒ Briefly immerse the test strips (1 sec.).
⇒ Gently shake off excess liquid from the test strip.
⇒ Read the result after 1 minute:
⇒ Determine the blend level in accordance with the table.
Test strips
Result
Blend level
Capacity
Filter cartridge M in
liters
Capacity
Filter cartridge L in
liters
► Setting the blend level
⇒ Press the key (9, Fig. 2) for blending adjustment and turn the blending adjustment dial to the corre-
sponding level (Fig. 2).
⇒ Remove the blending adjustment key after setting has been completed and store the key in a safe place
for possible future adjustments to the settings.
► Assembling the filter head
When assembling the sensor unit, the adapter and the water hoses, make sure that you use the
corresponding gaskets.
⇒ Screw one adapter (13) onto the inlet of the filter head (3, Fig. 1).
⇒ Securely attach the filter head to a wall in a vertical position using appropriate screws (not included in
the scope of delivery).
⇒ Screw one adapter (13) onto the connection of the sensor unit (10)
⇒ Screw the sensor unit (10) to the outlet of the filter head (4, Fig. 1) using the union nut.
⇒ Disconnect the POWER steamer 2 from the power source.
⇒ Turn off the water supply to the POWER steamer 2 and disconnect the water hose to the POWER
steamer 2 from the water supply.
⇒ Connect the water hose for the POWER steamer 2 to the adapter of the sensor unit.
The sensor unit must not be exposed to any mechanical loads.
⇒ Connect the water hose provided to the adapter at the inlet of the filter head and to the water supply.
⇒ Note the flow direction – markings on the filter head and sensor unit!
⇒ Max. torque 10 Nm.
Fig. 6: Typical installation example
4x green 1x red
3 3
3570 3060
6670 5710
- 3 -
2x red 3x red
2 2
1440 990
2690 1840
en
4x red
1
510
940