Tabla de contenido
Publicidad
SET UP (for use with remote control or sensor)
This procedure lets you program compatible transmitters for each of the 4 outputs.
PROCEDURE:
STEP 1
Press the button associated to the output you want to
program until red light is flashing.
Note: the example on the picture shows how to program
a transmitter for the output 1.
STEP 2
Within 60 seconds press/touch the ON or other related button shortly on
your controller or sensor. A green light will flash once on your
transmitter.
The red LED light on the module will flash 3 times. Now press/touch the
button on the controller or sensor again shortly. The controller or sensor
is connected.
Note: the button on your controller or sensor to program the module is
either the ON or other main button.
CONNECT WITH CONTROLLER OR SENSOR
NOTE: If you want to connect a conroller or sensor to control more than one output simultaneously, repeat the procedure
for each output that you want to control. It is advisable to program a maximum of 6 control units per single remote control.
MEC MODULE SMART 4
PRESS BUTTON SHORTLY
1
2
3
4
A
LED STARTS FLASHING
1
2
3
4
A
RED LED LIGHT FLASHES 3 TIMES
EN
4
Publicidad
Tabla de contenido
