Tabla de contenido
Publicidad
RESET MODULE/CONTROLLER
This procedure lets you delete the programmed memory from the module and controllers (transmitters).
PROCEDURE:
STEP 1
Hold the button associated to the output you want to
reset for about 5 seconds (until the LED begins to flash).
Note: the example on the picture shows how to program
a transmitter on output 1.
Smart 4 Controller: Select the channel on the
controller before you start the reset procedure.
DELETION OF SINGLE
TRANSMITTER
STEP 2A
Within 10 seconds press OFF or other related button on
controller or sensor for a short time. The LED starts flashing
quickly and turns off. Deletion is complete.
PRESS TRANSMISSION BUTTON ON
CONTROLLER OR SENSOR
1
LED STARTS FLASHING QUICKLY AND TURNS OFF
MEC MODULE SMART 4
2
3
4
A
PRESS BUTTON
(about 5 seconds)
DELETION OF ALL THE SAVED TRANSMITTERS
IN THE OUTPUT
STEP 2B
Within 10 seconds press the same button again and hold. The
LED starts flashing quickly and turns off. Deletion is
complete.
PRESS BUTTON
SHORTLY
LED STARTS FLASHING QUICKLY AND TURNS OFF
1
2
3
4
A
LED FLASHES
1
2
3
4
A
EN
5
Publicidad
Tabla de contenido
